A toilet that never quite stops is one of the most common calls we get, from Porthcawl to Cornelly and Pyle. It is rarely urgent, but it wastes water every minute of the day, and the hiss at night drives people mad.
Two parts do all the work
Lift the cistern lid and you will see two things:
- The fill valve, which lets water in after a flush and shuts off when the cistern is full. It is usually on one side, with a float.
- The flush valve, in the middle, which opens when you press the button and seals shut again to hold the water in the cistern.
Almost every running toilet is one of these two not doing its job.
Which one is it?
Water trickling into the pan constantly. Look at the water in the pan; if there is a steady ripple or a thin stream down the back, the flush valve seal is letting water past. The cistern then keeps topping itself up to replace it.
Water running into the overflow. If the cistern fills too high and spills into the overflow pipe, the fill valve is not shutting off. You may see water dripping from a small pipe outside, or into the pan through an internal overflow.
The cistern refills on its own every so often. That is the flush valve again, leaking slowly until the level drops enough to trigger a refill.
What you can check safely
- Make sure nothing is caught under the flush valve seal, such as a bit of debris.
- Check the float is not rubbing on the side of the cistern.
- If there is an isolating valve on the pipe into the cistern, you can turn it off to stop the waste until it is fixed. Flushing will then empty the cistern, so remember it is off.
The fix
It is usually a worn seal or a tired valve, and a straightforward swap. Older toilets sometimes need a full new fill valve or flush valve rather than a seal. Either way, you get the price before we start.
While we are there
If the toilet rocks, or there is damp around the base, mention it. A weeping pan seal is one of the usual causes of a stain on the ceiling below.