Porthcawl does not get many hard frosts, which is exactly why they catch people out. An outside tap on a wall facing the sea gets the wind as well as the cold, and a tap with water sitting in it can split overnight. You usually find out in spring, when you turn it on and the wall gets wetter than the garden.
How a properly fitted outside tap works
When we fit an outside tap, it goes in with an isolating valve inside the house, normally under the kitchen sink or wherever the pipe comes off. That valve lets you shut off the water to the outside run without touching anything else in the house.
Draining it down
Once a year, before the cold sets in:
- Find the isolating valve indoors and turn it off. On most, a quarter turn with a flat screwdriver puts the slot across the pipe.
- Go outside and open the tap fully. A little water will run out and then stop.
- Leave the outside tap open over winter so any water left can expand without cracking anything.
- In spring, close the outside tap and turn the indoor valve back on.
That is the whole job, and it takes less time than reading this.
If your tap has no valve inside
Plenty of older outside taps were teed straight off the cold main with no way to isolate them. Your options are to turn the whole house off at the stopcock to drain it, which is a nuisance, or have an isolating valve added. It is a small job and we price it before we start.
Covers and lagging
A foam tap cover helps on a cold night and costs very little. Lagging the pipe where it runs outside helps too. Neither is a substitute for draining the tap, because a cover keeps the tap a bit warmer, not frost proof.
Signs it has already split
- Water running down the wall when the tap is shut.
- Damp inside where the pipe goes through the wall.
- The tap spits or sprays from the body when you open it.
If you see any of these, turn off the indoor valve, or the stopcock if there is no valve, and give us a ring on 07712 646488.