Every house has one: the tap that drips just enough to notice. It is usually the job that has been annoying you for months, and it is usually done in one visit.
Why taps drip
It depends on the type of tap.
- Older taps with a crosshead or a handle you turn several times close by pressing a rubber washer down onto a seat. When the washer hardens or the seat wears, water gets past.
- Quarter turn taps and most mixers use a ceramic cartridge. When the discs inside wear or get scratched by grit, they let water through.
- Single lever mixers use a cartridge too, and a worn one can drip, or make the hot and cold hard to set.
Washers and cartridges can often be replaced. On older or cheaper taps, the parts can be hard to find, and a new tap is the better spend.
Isolating valves
An isolating valve is a small valve on the pipe feeding a tap, toilet or appliance. Turning it lets you shut off the water to just that one thing. You can usually spot them under a basin or kitchen sink, on the pipe below each tap, with a slot you turn with a flat screwdriver.
They matter because:
- a tap can be changed without turning off the water to the whole house,
- if a tap or hose fails, you can stop the water at that point straight away,
- the kitchen stays usable while the bathroom is being worked on.
If your basin or sink does not have them, we fit them when we change the tap.
Seized valves
Isolating valves that have not been touched for years can seize, or start to weep at the screw when turned. Do not force one. If it will not move, or starts dripping, leave it and tell us when you book.
New taps
If you are changing a tap anyway, measure the hole in the basin or sink and note whether it is one hole or two. A photo of the underneath of the old tap helps us bring the right fittings.
Getting it sorted
Send a photo of the tap and the pipes under it on WhatsApp with your postcode. You get the price before we start, and the work carries our 1 year warranty.